Dometic WAECO CoolMatic HDC-150 Montage- Und Bedienungsanleitung Seite 31

_HDC150.book Seite 31 Donnerstag, 9. Dezember 2010 8:19 20
HDC-150
NOTICE!
A
Ensure that the ventilation vents are not covered.
Keep the drainage outlet clean at all times.
Check that the voltage specification on the type plate is the
same as that of the power supply.
Do not open the refrigerant circuit under any circumstances.
Never transport the device in a horizontal position, so that no oil
can leak out of the compressor.
Set up the device in a dry location where it is protected against
splashing water.
Do not place it near naked flames or other heat sources (heat-
ers, direct sunlight, gas ovens etc.).
Food may only be stored in its original packaging or in suitable
containers.
The appliance is not suitable for the storage of caustic materials
or materials containing solvents.
Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick charg-
ing device.
Overvoltage can damage the electronics of the device.
2.2 Operating the appliance safely at 100 V–240 V
CAUTION!
!
Before starting the device, ensure that the power supply line
and the plug are dry.
NOTICE!
A
Only use the cable supplied to connect the appliance to the AC
mains.
Never pull the plug out of the socket by the cable.
Check that the voltage specification on the type plate is the
same as that of the power supply.
Safety instructions
31