Electrolux IK327SA Benutzerinformation Seite 15

Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the FastFreeze
Shopping, or after chang‐
ing the temperature.
Water flows into the refrig‐
erator.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The Shopping function is
switched on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent that
water flows into the water
collector.
The FastFreeze or Shop‐
ping function is switched
on.
The appliance is in demon‐
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
ENGLISH
Solution
Refer to " Shopping func‐
tion".
Refer to "Closing the door".
Position the water drain‐
age plug in the correct
way.
Wrap the food products
better.
Refer to "Operation" chap‐
ter.
The compressor starts af‐
ter a period of time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets au‐
tomatically to set the tem‐
perature. Refer to "Fast‐
Freeze function" or " Shop‐
ping function".
Keep the OK button press‐
ed for approximately 10
seconds until a long sound
is heard and display shuts
off for a short time.
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
15