Spit F40 Bedienungs- Und Wartungsanleitung Seite 12

Instructions for use
Dust exhausting
Maintenance
Grinding cutters
wear
Disposal
10
The tool may only be used with a dust exhaustion.
A good ventilation of the working place has to be ensured.
The vacuum cleaner must be adapted for exhausting stone dust and
show sufficient suction speed. Additionally, a dust-protective mask has
to be worn according to DIN/EN against fine dust.
The wall chaser contains a dust exhausting socket (E), which is inte-
grated on the left side of the tool. After removal of the protection cap,
a hose with internal diameter of 35 mm can be attached.
Please note: whenever an escape of dust can be observed during
the application, please shake up the filter of the vacuum cleaner
immediately.
Re-grind cutters in due time without water in arrowed direction or
return them for re-grinding.
Use a silicon-carbide-disk (green).
The machine has self-disconnecting carbon brushes. When the
brushes are worn the motor will switch-off automatically, then a rou-
tine-service is necessary.
For maintenance and repair servicing, details can be obtained from
your local branch.
The manufacturer will not be responsible for any tools which have
been maintained, repaired or modified by agents not formally approved
by the manufacturer.
We advise you to bring the tool in regular times in service for main-
te nance according to the frequency of usage in order to prevent
accidents, injuries or the damage of the tool.
Only for EU countries
Do not dispose of electric tools together with household waste material!
In observance of European Directive 2002/96/EC on waste electrical
and electronic equipment and its implementation in accordance with
national law, electric tools that have reached the end of their life must
be collected separately and returned to an environmentally compatible
recycling facility.