Safety Warnings - Märklin BR 52 Bedienungsanleitung

Function
• Possible operating systems: 6646/6647 Märklin
Transformer, Märklin Delta, Märklin Digital, Märklin
Systems.
• Recognition of the mode of operation: automatic.
• Addresses that can be set: 01 – 80.
Address set at the factory: 52.
• Mfx technology for the Mobile Station /
Central Station. Name set at factory: BR 52 3407
• Adjustable acceleration.
• Adjustable Braking delay.
• Adjustable maximum speed.
• Setting the locomotive parameters electronically with
the Control Unit, Mobile Station or Central Station.
• Built-in sound effects circuit, can only be used in
operation with the Control Unit or Märklin Systems.
• Additional sound effects that can be controlled.
• A smoke generator can be retrofitted to the
locomotive - also for analog operation
The maintenance work necessary with normal
operation of this locomotive is described below.
Please see your authorized Märklin dealer for
repairs or spare parts.
6

Safety Warnings

• This locomotive is to be used only with an
operating system designed for it (Märklin
6646/6647 AC transformer, Märklin Delta,
Märklin Digital or Märklin Systems). Under
no circumstances should transformers rated
for an input of 220 volts be connected to the
American 110 volt household current system.
• This locomotive must never be supplied with
power from more than one transformer.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation.
The 74046 interference suppression set is to be used
for this purpose. The interference suppression set is
not suitable for digital operation.
• Pay close attention to the safety warnings in
the instructions for your operating system.
No warranty or damage claims shall be accepted in those cases
where parts neither manufactured nor approved by Märklin have
been installed in Märklin products or where Märklin products have
been converted in such a way that the non-Märklin parts or the
conversion were causal to the defects and / or damage arising.
The burden of presenting evidence and the burden of proof there-
of, that the installation of non-Märklin parts or the conversion in or
of Märklin products was not causal to the defects and / or dama-
ge arising, is borne by the person and / or company responsible
for the installation and / or conversion, or by the customer.