Connecting The Camera - Monacor TVCCD-462COL Bedienungsanleitung

3) When using an AI lens, connect this lens to
GB
the jack AUTO IRIS (12). Solder the connec-
tion cable of the lens – according to the pin
configuration for the lens type used listed in
the table – to the supplied 4-pole plug, then
connect this plug to the jack.
2
4
for a DC
Pin
controlled lens
1 damp -
2 damp +
3 drive +
4 drive -
14
1
3
➃
4-pole jack (solder side)
for a lens controlled
by video signal
power supply +12 V
not connected
output of video signal
ground
5 Mounting
The camera can be installed on a camera sup-
port (e. g. support of the MONACOR TVH-...
series), on a camera stand, or on a pan/tilt head
(e. g. MONACOR VPT-50). For this purpose, the
lower side of camera is provided with an adapter
(9) with thread jack [thread 6.3 mm (
suspended installation, this adapter can alterna-
tively be screwed to the upper side of the cam-
era.
For outside installation, the camera must be
placed in a weatherproof housing.

6 Connecting the Camera

Connect the BNC jack VIDEO (6) to the video
input of the following unit (e. g. monitor, camera
switcher, video splitter) via a 75 Ω cable (e. g.
MONACOR BNC-1000). With a cable length ex-
ceeding 100 m, a video amplifier should be in-
serted between the camera and the cable to
compensate cable loss.
For power supply, connect a regulated power
supply unit (e. g. MONACOR PS-12CCD) with
1
/ ")]. For
4