Setting Time; Setting The Alarm - Blaupunkt BTD-7000 Benutzerhandbuch

User manual
DC operation
1. Remove the lid of the battery compartment.
2. Insert 4 R14/UM2/"C"size batteries into the compartment. Make sure to match their polarities (+/-) to the markings
inside the compartment.
3. Put the lid back in place.
Note:
-The AC cord must be unplugged from both the socket on the unit and the power outlet for the unit to run on the
batteries.
- When the set is connected to the mains, the power source automatically switches to AC.
- The appearance of battery icon "
Notes on batteries (not supplied)
·Do not mix different types of batteries or old batteries with new ones.
·Never recharge the batteries, apply heat to them or take them apart.
·Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
·Do not throw the batteries in fire!
·Attention should be drawn to the environmental aspects of battery disposal.
·The batteries need to be replaced when: The volume decreases, or sound is distorted during operation.
·In order to avoid leakage, remove the batteries when unit will not be used for a long period of time.
·Please respect the environment. Before throwing any batteries away, consult your distributor who may be able to take
them back for specific recycling.
CAUTION:
Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type.

SETTING TIME

1. In standby mode, press MEMO for two seconds and the display will show "24 HOURS". .
2. Press or to select "24 HOURS" or "12 HOURS" time format.
3. Press MEMO to confirm and the hour digits flash.
4. Press or to set the hour value. Press MEMO to confirm and minute digits flash.
5. Repeat Step 4 until minute, year, month, day are set.

SETTING THE ALARM

Set alarm time and wake source
2. In Standby mode, long press ALARM button until "ALARM OFF" appears on display.
2. Press or to select "ALARM ON" and press ALARM to confirm. "ALM" icon appears and the hour digits flash on
display.
3. Press or to adjust hour value. Then press ALARM to confirm and minute digits flash.
4. Press or to adjust minute value and press ALARM to confirm.
5. Press or to select the wake source among " FM", "BUZZER" and "MW". Then press ALARM to confirm. (When
"FM" or "MW" is selected. press
6. Press or to select alarm frequency among "WEEKENDS", WEEKDAYS", "ONCE" and " DAILY" . Then press
ALARM to confirm.
WEEKENDS: The alarm is activated only on weekends.
WEEKDAYS: The alarm is activated only on weekdays.
ONCE: The alarm is activated only one time.
DAILY: The alarm is activated everyday.
7. Press or to adjust the alarm volume level and press ALARM again to confirm the alarm setting. The "ALM" icon
remains on the display.
Silence the alarm momentarily
Press SNOOZE/DIMMER to turn the alarm off temporarily. The alarm will sound again when the snooze period is over.
Note: snooze time is 9 minutes.
Stop the alarm
Press ON/OFF. The alarm will turn on at the same time tomorrow except followings situations:
4. "ONCE" is selected. The alarm is cancelled and "ALM" icon disappears from the display.
5. "WEEKDAYS" is selected and tomorrow is Saturday. The "ALM" icon remains on the display.
" on display indicates that the batteries are low. Replace them with new batteries.
or to select a preset number and press ALARM to confirm.)
BTD-7000 / BTD-7001
8