Inhaltsverzeichnis
Werbung
User manual
Connecting power
Connect an AC adapter (not supplied) to the DC IN 5V jack of the unit and to the mains socket.
Caution!
• Check that the voltage marked on the adapter rating plate matches your local supply.
• Never use an AC adaptor that is damaged, route power lead in a safe manner and make sure it is not subjected to
trapping or pinching. If the power lead is damaged refer to a qualified service agent.
•The AC adaptor is used as the disconnect device and it shall remain readily operable. To be completely disconnected from
the power input, the AC adaptor shall be disconnected from the mains completely. The AC adaptor should not be
obstructed or should be easily accessed during intended use.
Battery operation
1. Remove the lid of the battery compartment by sliding it outward in the direction of the arrow.
2. Insert 3 R6/UM3/AA batteries into the compartment. Make sure to match their polarities (+/-) to the markings inside the
compartment.
3. Put the lid back in place.
Notes on batteries (not supplied)
·Do not mix different types of batteries or old batteries with new ones.
·Never recharge the batteries, apply heat to them or take them apart.
·Batteries should not be exposed to excessive heat such as sunshine, fire or the like.
·Do not throw the batteries in fire!
·Attention should be drawn to the environmental aspects of battery disposal.
·The batteries need to be replaced when: The volume decreases, or sound is distorted during operation.
·The appearance of battery icon "
·In order to avoid leakage, remove the batteries when the unit will not be used for a long period of time.
·Please respect the environment. Before throwing any batteries away, consult your distributor who may be able to take
them back for specific recycling.
CAUTION:
Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type.
SETTING TIME
After the batteries are installed, the display will show "0:00".
1. Press MEMO once to enter the time setting mode. The display will show flashing "24 HR". Then press tuning
select 24H or 12H time format.
2. Press MEMO again to confirm and the hour digits flash.
3. Press tuning
/
4. Press tuning
/
SETTING THE ALARM
Set alarm time
2. In Standby mode, keep the ALARM button pressed until the "ALM" indicator is displayed and the hour digits flash on
display.
2. Press tuning
/
3. Press tuning
/
Set wake up source
Press ALARM repeatedly to select the wake up source among "
• Wake to buzzer sound
displays and buzzer sound will come out when the alarm time is reached.
• Wake to radio
3. Follow procedures in "Listen to the radio" to select your desired radio station and adjust the alarm sound level.
4.
displays and the station selected above will play when the alarm time is reached.
" on display indicates that the batteries are low. Replace them with new batteries.
to set the hour value. Press MEMO to confirm and minute digits flash.
to set the minute value and press MEMO again to confirm.
to adjust hour value. Then press ALARM to confirm and the minute digits flash.
to adjust minute value and press ALARM to confirm.
" and "
".
BD-320 / BD-321
/
to
7
Werbung
Inhaltsverzeichnis
