ZyXEL P-661HNU-Fx-series Schnellstartanleitung Seite 5

2. ETHERNET: If you want a wired connection to the P-661HNU-Fx, use
an Ethernet cable to connect a computer to one of these ports for
initial configuration and/or Internet access.
3. USB 2.0: You only need to use this port if you are connecting a USB
storage device, USB printer or a 3G adapter to the P-661HNU-Fx.
4. ANTENNAS: Attach the included antennas.
5. POWER: Use the power adaptor provided with your P-661HNU-Fx to
connect this socket to an appropriate power source.
6. Push the power button to the on position and look at the LEDs (lights)
on the top panel of the P-661HNU-Fx.
• The POWER light blinks during start-up and stays on once the P-
661HNU-Fx is ready.
• The ETHERNET light turns on if the corresponding ETHERNET
port is properly connected. If you do not connect a computer
correctly to this port, the ETHERNET light will not turn on.
• The WLAN/WPS stays on when the wireless LAN is ready. The
light will not turn on if the Wireless Connection is not activated.
The ETHERNET and WLAN/WPS lights blink when the P-661HNU-Fx is
sending or receiving data. If the POWER light does not turn on during
start up, try turning the P-661HNU-Fx off, check the connections, wait a
few seconds and then turn it back on. If the problem persists, you may
have a hardware problem and you need to contact your vendor.
ENGLISH
5