Trouble Shooting; Repairs; Environmental Protection - Metabo BasicAir 350 Originalbetriebsanleitung

ENGLISH
4. Store device in such way that it can-
not be started by unauthorised per-
sons.
A
Caution!
Do not store or transport machine un-
protected outdoors or in a damp envi-
ronment.
Do not lay machine on its side for trans-
port or storage.
7.

Trouble Shooting

A
Danger!
Prior to all servicing:
– Switch machine OFF.
– Unplug power cable.
– Wait until the compressor has come
to a complete stop.
– Ensure the compressor and all air
tools and accessories connected to
it are relieved from pressure.
– Let the device and all air tools and
accessories cool down.
After all servicing:
– Check to see that all safety devices
are operational.
– Make sure that no tools or other
parts remain on or in the machine.
Compressor does not run:
No mains voltage.

– check cables, plug, outlet and
mains fuse.
 Mains voltage too low.
– Use only extension cables with
sufficient lead cross section (see
14
"Technical Specifications").
When the machine is cold avoid
extension cables and relieve the
pressure in the pressure vessel.
 Compressor was stopped by un-
plugging.
– Switch compressor OFF at the
On/Off switch, then ON again.
 Motor has overheated, caused by
insufficient cooling (cooling fins cov-
ered).
– First switch off the compressor
using the ON/OFF switch and al-
low to cool.
– Eliminate the cause of overheat-
ing.
– Switch the compressor back on.
Compressor runs but does not build
up sufficient pressure.
Condensation water drain on pres-

sure vessel leaky.
– Check the sealing of the outlet
screw(s); replace if necessary.
– Tighten the outlet screw(s) hand-
tight.
Check valve leaky.

– Have check valve serviced by
qualified service centre.
Air tool is not supplied with suffi-
cient pressure.
 Pressure regulator not opened wide
enough.
– Open pressure regulator more.
 Hose connection between compres-
sor and air tool leaky.
– Check air hoses, replace defec-
tive parts if necessary.
Further work on the machine should
only be carried out by a qualified
electrician or the Service Centre in
your country.
8.

Repairs

A
Danger!
Repairs to electric tools must be carried
out by qualified electricians only!
Electric tools in need of repair can be
sent to the Service Centre in your coun-
try. See Spare Parts List for address.
Please attach a description of the fault
to the power tool.
9. Environmental Protec-
tion
A
Danger!
The condensation water from the pres-
sure vessel contains oil residues. Dis-
pose of the condensation water in an
environmentally-oriented manner at an
appropriate collection point!
A
Danger!
Dispose of the waste oil from the com-
pressor pump in an environmentally-ori-
ented manner at an appropriate collec-
tion point!
The tool's packaging can be 100% re-
cycled.
Worn out machines and accessories
contain considerable amounts of valua-
ble raw and plastic materials, which can
be recycled.
These instructions are printed on paper
produced with an elemental chlorine-
free bleaching process.