Restore Default Settings And Update Firmware; Cleaning - Ecler CA200z Bedienungsanleitung

4.7. Restore default settings and update firmware

To restore the CA200z to factory settings, follow this procedure:
1. Press and hold the front rotary encoder knob with the unit switched off
2. Keeping it pressed, switch on the unit with the ON/OFF switch on the rear panel. The LCD
panel will show a special message indicating that the CA200z is ready to be switched
off in order to recover the default adjustment mode when it is switched on again
3. Wait a few seconds and then switch the CA200z off again
4. The next time it is switched on, the factory settings will be in the memory
Note: for instructions on how to update the unit's firmware, see the product web page at
www.ecler.com, where you will find the update software utility and instructions on how to proceed.

5. CLEANING

The CA200z must not be cleaned with solvents or abrasive substances which may
damage the prints. Clean using a cloth moistened in water and a neutral liquid detergent, then dry
with a clean cloth. Under no circumstances allow water to enter any of the orifices in the equipment.
21