Operation; Basic Operation - Fiat CLARION PU2312 Bedienungsanleitung

6. OPERATION

Note: Be sure to read this chapter referring to the front diagrams of chapter "3. CONTROLS" on page
5 (unfold).

Basic Operation

é CAUTION
Be sure to set the volume to the minimum level
before turning off the power to the unit.
Loud sounds when turning on the power may
impair your hearings or cause damage to the
unit.
Turning on/off the power
Note:
• Do not use the sound system for a long time when
the engine is off. You may have problems in start-
ing the engine or shorten the life of the battery.
1. Press POWER button 3.
2. The illumination and display on the unit light up.
The unit automatically remembers its last oper-
ation mode and will automatically switch to dis-
play that mode.
3. Press and hold POWER button 3 for 1 second
or longer to turn off the power for the unit.
Selecting a mode
1. Press FNC button 3 to select a function mode.
2. The function mode changes in the following
order:
Radio ➜ CD ➜ CD/MD
* If the CD/MD
CHANGER
MD mode cannot be selected.
CHANGER
Adjusting the volume
Turning the rotary knob % clockwise increases
the volume; turning it counterclockwise decreases
the volume.
* The volume level is from 0 (minimum) to 33
(maximum).
8
➜ Radio ...
CHANGER
is not connected, the CD/
Setting the Z-enhancer
This unit comes with 3 types of sound tone effects
stored in memory. Select the one you prefer.
* The factory default setting is "OFF".
Each time you press Z-EHCR button @, the tone
effect changes in the following order:
"Z-ENHANCER 1" ➜ "Z-ENHANCER 2" ➜
"Z-ENHANCER 3" ➜ "OFF" ➜ "Z-ENHANCER 1"...
• Z-ENHANCER 1 : bass emphasized
• Z-ENHANCER 2 : treble emphasized
• Z-ENHANCER 3 : bass and treble emphasized
• OFF
: no sound effect
Adjusting the tone
Press A-M button 2 and select the item to adjust.
Each time you press A-M button 2, the item
changes in the following order:
"BASS" ➜ "TREB" ➜ "BAL" ➜ "FAD" ➜
Function mode...
Adjusting the bass
2 and select "BASS".
1. Press A-M button
2. Turning the Rotary knob % clockwise empha-
sizes the bass; turning it counterclockwise
attenuates the bass.
* The factory default setting is "0".
(Adjustment range: –6 to +6)
3. When the adjustment is complete, press A-M
button 2 several times until the function mode
is reached.
Adjusting the treble
1. Press A-M button 2 and select "TREB".
2. Turning the rotary knob
sizes the treble; turning it counterclockwise
attenuates the treble.
* The factory default setting is "0"
(Adjustment range: –6 to +6)
3. When the adjustment is complete, press A-M
button 2 several times until the function mode
is reached.
% clockwise empha-