Function; Led Display - Balluff BTL7-C508-M____-P-S32 Series Betriebsanleitung

BTL7-C/E5_ _-M _ _ _ _ -P-S32/KA _ _
Micropulse Transducer in a Profile Housing
3
Construction and function (continued)
3.2

Function

The BTL7 transducer contains the waveguide which is
protected by an aluminum housing. A magnet is moved
along the waveguide. This magnet is connected to the
system part whose position is to be determined.
The magnet defines the position to be measured on the
waveguide.
An internally generated INIT pulse interacts with the
magnetic field of the magnet to generate a torsional wave
in the waveguide which propagates at ultrasonic speed.
The component of the torsional wave which arrives at the
end of the waveguide is absorbed in the damping zone to
prevent reflection. The component of the torsional wave
which arrives at the beginning of the waveguide is
converted by a coil into an electrical signal. The travel time
of the wave is used to calculate the position. Depending
on the version, this information is made available as a
voltage or current with rising or falling gradient.
The following functions can be selected for the output
values:
– Position
– Speed (with or without leading sign)
The entire function scope can only be
configured with the PC software "Micropulse
Configuration Tool". To do this, the USB
communication box must be connected (see
Accessories on page 18).
8 english
3.3

LED display

LED 1 LED 2
Fig. 3-2: BTL7 LED displays
In normal operation LED 1 indicates the
operating state of the transducer.
LED 1 LED 2 Operating state
Normal function
Green Off
Magnet is within the limits.
Red Off Error
No magnet or magnet outside the limits.
Green or Flashing Programming mode
red green