Configuration With The Micropulse Configuration Tool; Value Table For Factory Setting; Micropulse Configuration Tool; Connecting The Usb Communication Box - Balluff BTL7-C508-M____-P-S32 Series Betriebsanleitung

BTL7-C/E5_ _-M _ _ _ _ -P-S32/KA _ _
Micropulse Transducer in a Profile Housing
6

Configuration with the Micropulse Configuration Tool

6.1

Value table for factory setting

Output gradient Transducer
Rising BTL7-C...
BTL7-E...
Falling BTL7-C...
BTL7-E...
Tab. 6-1: Value table for factory settings
NOTICE
Interference in function
Configuration with the Micropulse Configuration Tool
while the system is running may result in malfunctions.
► Stop the system before configuration.
6.2

Micropulse Configuration Tool

The BTL7-C/E5_ _-... transducer can be configured
quickly and simply on a PC using the Micropulse
Configuration Tool PC software.
The most important features include:
– Online display of the current position of the magnet
– Graphical support for setting the functions and curves
– Display of information on the connected transducer
– Selectable number formats and units for display
– Resetting to factory settings is possible
– Demo mode without having transducer connected
The PC software and associated manual can be
found in the Internet under www.balluff.com.
14 english
Unit Min. value Null value
mA 0
mA 3.2 4.0
mA 20.4 20.0
mA 20.4 20.0
6.3
With a BTL7-C/E5_ _-...-S32 transducer (with connector),
the communication box must be looped in between the
transducer and controller. The communication box is
connected to the PC via a USB cable.
Connection cable approx.
0.3 m with S32 (female)
connector
Fig. 6-1: Connecting the communication box with a connector
With a BTL7-C/E5_ _-...-KA_ _ transducer, the
communication lines La, Lb and GND must be connected
to the USB communication box.
Fig. 6-2: Connecting the communication box with a cable connection
End value Max. value
0 20.0 20.4
20.0 20.4
0
4.0 3.2

Connecting the USB communication box

USB cable
8-pin
8-pin
USB cable
When reading or writing data via the
Configuration Tool, LED 2 flashes green.
Error value
20.4
20.4
0 0
3.2
Connection cable
approx. 0.3 m with
S32 (male) connector
Controller
6-pin
Controller
Connection cable
approx. 0.6 m with
luster terminal