SOPRO COMEG SYMBIOZ Led Betriebsanleitung Seite 24

12
ELECTRO-MAGNETIC
COMPATIBILITY
Manufacturer's guide and declaration - electromagnetic safety
The equipment referenced "LED Source" is intended to be used in the electromagnetic environment specified below.
The user must ensure that it is used in this environment.
Safety test IEC 60601
Severity level
Conducted RF 3 Vrms
IEC 61000-4-6 150 kHz to 80 MHz
Radiated RF IEC 3 V/m
61000-4-3 80 MHz to 2.5 GHz
Remark 1: At 80 MHz and 800 MHz, it is appropriate to use the highest frequency band.
Remark 2: These recommendations may not be applicable to all situations. The propagation of electromagnetic waves is modified by
the absorption and reflection due to the structures, objects, and people.
For transmitters whose maximum output power is not listed on the table above, the recommended separation distance d, in metres
(m) can be established using the equation applicable to the frequency of the transmitter, in which P is the maximum output power
of the transmitter in watts (W) assigned by the manufacturer of the transmitter.
Compliance Electromagnetic environment - guide
tests
The portable and mobile RF communications equipment should not be used
at a distance of this product - including cables - lower than what is recom-
mended, calculated by applying the formula that corresponds with the fre-
quency of the transmitter.
d = 1,16 √ P
3V
d = 1,16 √ P 80 MHz to 800 MHz
3V/m d = 2,33 √ P 800 MHz to 2.5 GHz
In which P is the maximum power output from the transmitter in watts (W),
assigned by its manufacturer and (d) is the recommended separation dis-
tance in meters (m).
The levels of fields emitted from transmitters RF fixed - which must be es-
tablished by a electromagnetic measurement in situ - must be less than
the compliance level in each frequency band. Interference may occur with
devices on which is placed.
The following symbol:
- 24 -