Rds - Teac T-R610 Bedienungsanleitung

The Radio Data System(RDS) is a broadcasting service which
allows stations to send additional information along with the
regular radio programme signal.
RDS works on the FM waveband in Europe only.
1
Tune in an FM station (by following steps
page 7).
2 Press the RDS MODE button.
Each time the RDS MODE button is pressed briefly, the RDS
mode is changed as follows:
PS (Programme Service name)
When you select PS, "PS" will blink for about 4 seconds and
then PS or a station's name will be displayed. If there is no
PS data, the frequency will be displayed.
PTY (Programme Type)
When you select PTY, "PTY" will blink for about 4 seconds
and then the programme type will be displayed.
RT (Radio Text)
When you select RT, "RT" will blink for about 4 seconds and
then the news of stations composed of up to 64 symbols
will be displayed.
TA (Traffic Announcement)
When you select TA, "TA" will blink for 4 seconds and then
the unit searches for a traffic announcement.
< If the station stops broadcasting traffic announcement, the
tuner will find other stations repeatedly.
If there is no PTY/RT data, RDS mode will be switched
to PS mode automatically.
When the A-R610 and T-R610 is connected by a remote
control cord:
After selecting TA, you can select any other source by turning
the INPUT SELECTOR of the A-R610.
If a station broadcasting traffic announcement is found, the
INPUT SELECTOR of the A-R610 will be automatically
switched to "TUNER". If the station stops broadcasting traffic
announcement, the INPUT SELECTOR will automatically return
to the previously selected source.
10

RDS

CT (Clock Time)
displays the information about times provided from the
station.
When you turn on the CT mode, "CT" will blink for about 4
seconds and then the clock time will be displayed.
To turn on or off the CT mode, press and hold the RDS
1 3
to on
MODE button for more than 10 seconds.
< The clock setting will be automatically adjusted according to
the CT data.
If you tune in an RDS station broadcasting incorrect CT data,
the clock might be wrongly adjusted, and that may eventually
affect the timer operation.