Troubleshooting; Maintenance - CO/Tech M1R-KZ3-8-UK Bedienungsanleitung

Troubleshooting

Symptom
The machine does
not start.
The machine
runs slowly.
Strange noise.
Strong vibrations.
Sparks in the motor.

Maintenance

Warning:
• Always unplug the machine before carrying out any maintenance or repairs.
• Always keep the motor's ventilation openings free of dust and debris.
• Regularly clean the machine using a cloth moistened with a little detergent.
• Never use solvents.
Disposal
Follow local ordinances when disposing of this product. If you are
unsure about how to dispose of this product contact your municipality.
Possible cause
No power.
Worn brushes.
Short circuit.
Faulty power switch.
Worn/damaged cutter/bit.
Speed too low.
The motor is overheated.
Mechanical fault.
Faulty windings.
Loose cutter/bit.
Brushes jammed.
Winding short circuited.
Dirt on commutator.
11
Remedy
Check the power point.
Contact us in case of motor
or electrical faults.
Sharpen or change
the cutter/bit.
Do not press down too hard.
Contact us in case of motor
or electrical faults.
Tighten the tool and make
sure it is set correctly.
Contact us in case of motor
or electrical faults.