Time/Date Settings; Preparations For Measurement; Commissioning - Trotec SL300 Bedienungsanleitung

04. TIME/DATE SETTINgS

- press the a/c button and switch the appliance on. re-
lease the a/c button as soon as the abbreviation "set"
appears on the display. the appli-
ance is now in calibration mode.
the date is shown on the display as
follows: date 28.08.200
- press the a/c button a second
time to display the time: time
16:58:18
- press the a/c button a third time
to set the minutes (shown on the
display as -- xx-1 )
- press the a/c button a fourth
time to set the hours (shown on
the display as -- xx-2 )
- press the a/c button a fifth time
to set the date (shown on the
display as -- xx-3 )
- press the a/c button a sixth time
to set the month (shown on the
display as -- xx-4 )
- press the a/c button a seventh
time to set the year (shown on
the display as -- xx-5 )
- press the a/c button for the
eighth time - rst-6 - reset ap-
pears on the display
to save the changes that you have made, you must
(!!!) press the a/c button again; this returns you to the
date display. press the hold button. the changes that
you made have been saved.
B - 3
if a flat battery has been replaced and the time cannot
be set, the time measurement chip must be initialised
beforehand.
depending on which section of the menu you are in,
the value can be increased with the level button and
decreased with the max/min button. note: the chan-
ges you make are always saved if the hold button is
pressed in the modes --xx-1 to xx---5. conversely, if
you press the hold button when you are in the menu
section rst-6 - reset, then the time and date are reset
to the factory settings. in each case the appliance is
placed in measurement standby mode after pressing
the hold button.
01. remove the lid from the battery compartment on
02. replace the lid on the battery compartment.
03. the
01. switch the appliance on.
02. press the level button to set the desired level. the
03. select dBa to measure the general sound level
04. select "Fast" for a fast response time and
05. select maX/min to measure the maximum or mi-
06. measurements are performed from a distance of
Operating instructiOns – sOund leVel meter sl300

05. PREPARATIONS FOR MEASUREMENT

the back of the appliance and insert a 9V battery.
symbol appears on the display as soon as
- +
the battery is too weak and the voltage falls below the
operating voltage. in this case, insert a new battery.

06. COMMISSIONINg

words "under" or "OVer" do not appear on the
display.
and dBc to measure acoustic material.
"slOW" to display the average sound level.
nimum noise level respectively.
1 m to 1.50 m. the appliance can be used hand-
held or mounted on a tripod.
EN