How It Works - Velleman CS130 Bedienungsanleitung

5. Overview
Refer to the illustrations on page Error! Bookmark not defined. of this manual.
metal detector
A arm rest
B handle with trace button
C control box
D battery compartment
control box + indicator
1 LOW BAT
2 VOLUME
3 TUNE
4
5 DISC
6 analogue meter
6.

How it works

 A (low frequency) metal detector basically consists of a transmitter, a receiver and a microprocessor
(control box) which handles the signals.
Transmitter
 The transmitter is a coil of wire located inside the search coil. By sending an alternating current through
this coil a magnetic field is generated, having a polarity pointing either into or out of the ground. This
magnetic field will induce a flow of current inside nearby metallic objects. These objects in turn will create a
magnetic field with a polarity which is usually opposite to that of the magnetic field of the transmitter.
Receiver
 The receiver is another coil of wire that is located inside the search coil and which is constructed in such a
way that the magnetic field of the transmitting coil does not induce current in it. Magnetic fields from
nearby metallic objects however will produce an electric current in the receiver coil.
Phase shift
 The signal received from the receiving coil will usually be delayed versus the transmitted signal due to the
tendency of conductors to impede changes in the flow of current, the so called inductance. The delay is
referred to as phase shift. Metal objects that are primarily inductive e.g. large thick objects made of good
conductors (gold, silver, copper...) will result in large phase shifts, whereas metal objects that are primarily
resistive e.g. smaller thin objects made of less conductive materials will result only in minor phase shifts.
Refer to the table below for a short overview of the electrical conductivity of some materials.
Material
silver
copper
gold
aluminium
calcium
zinc
 Note that detection also depends on the size, shape, depth... of the metal.
V. 03 – 08/09/2017
low battery indication: lights up when voltage drops below 8.8V
volume button: set speaker or headphone volume to normal or low
"ground balance control": to eliminate background signals caused by mineralized
soils
headphone jack: to connect an external headphone (not incl.)
discrimination control: to eliminate (notch) undesired metals
Note: this setting influences the sensitivity
needle indicates metal type
Electrical
conductivity (S/m)
63.01 × 10
59.6 × 10 6
45.2 × 10 6
37.8 × 10 6
29.8 × 10 6
16.6 × 10 6
CS130
E upper shaft
F locking nut
G lower shaft
H coil knob
I search coil
Material
6 nickel
iron
platinum
tin
sea water
drinking water
4
Electrical
conductivity (S/m)
14.3 × 10 6
9.93 × 10 6
9.66 × 10 6
9.17 × 10 6
4.788
0.0005 ~ 0.05
©Velleman nv