Electrical Connections; Maintenance / Cleaning; Important Information Concerning The Environmentally Compatible Disposal - Vortice LINEO 100 ES Betriebsanleitung

ENGLISH
Select the pre-set speeds
The user can change between V min and V max using
an external switch (not supplied)
NOTE
Increasing the speed of the motor leads to greater
power consumption and higher noise levels.
NOTE
Lineo ES series products can be operated in
conjunction with environmental sensors and timers
that switch the products on at a preset speed when
certain thresholds are reached e.g. Relative Humidity
(C HCS), Temperature (C TEMP), Smoke (C Smoke), if
the vicinity detector is activated (C Pir) or while the
Timer is being set (C Timer).
Restoring the original speed settings (set by
installer) (Mod.250)
- With the appliance turned off, change the original
settings of the dip-switches shown in fig 22. The
new setting will only be temporarily valid and must
be that shown in Table D.
- Fully turn the Max and Min speed adjuster anti-
clockwise.
- Turn the appliance on and let it run for at least 10
minutes.
- Turn the appliance off and restore the original dip-
switch settings (table C)
- Turn the Minimum and Maximum speed adjusters
clockwise to the half-way stage.
- Turn the appliance on again.
TAB C
Model
LINEO 250 ES
TAB D (RESET)
Model
LINEO 250 ES

Electrical Connections

Lineo ES: Fig. 23
Accessoires: Fig. 24,25,26
Configuration
ON
OFF
1 2 3 4
Configuration
ON
OFF
1 2 3 4

Maintenance / Cleaning

Fig. 27,28,29
Important information
concerning the
environmentally compatible
disposal
IN CERTAIN EUROPEAN UNION COUNTRIES THIS
PRODUCT DOES
REQUIREMENTS OF THE NATIONAL LAWS
IMPLEMENTING DIRECTIVE WEEE, AND IN
THESE COUNTRIES THE PRODUCT IS NOT
SUBJECT TO SEPARATE DISPOSAL OPERATIONS
AT THE END OF ITS WORKING LIFE.
This product conforms to EU Directive2002/96/EC.
This appliance bears the symbol
of the barred waste bin. This
indicates that, at the end of its
useful life, it must not be disposed
of as domestic waste, but must be
taken to a collection centre for
waste electrical and electronic
equipment, or returned to a
retailer on purchase of a replacement.
It is the user's responsibility to dispose of this
appliance through the appropriate channels at the
end of its useful life. Failure to do so may incur the
penalties established by laws governing waste
disposal.
Proper differential collection, and the subsequent
recycling, processing
compatible disposal of waste equipment avoids
unnecessary damage to the environment and
possible related healthrisks, and also promotes
recycling of the materials used in the appliance.
For further information on waste collection and
disposal, contact your local waste disposal service,
or the shop from which you purchased the appliance.
Manufacturers and
responsibilities for
environmentally compatible disposal either directly or
by participating in collective systems.
NOT FALL WITHIN
and environmentally
importers fulfil
recycling, processing
THE
their
and