Operating Elements And Connections; Safety Notes - IMG STAGELINE MMX-512 Bedienungsanleitung

Please unfold page 3. Then you will always see the
GB
operating elements and connections described.
1

Operating Elements and Connections

1 MIC input (XLR, bal.) for connecting a micro-
phone to mono channel 1
2 – 4 LINE inputs (6.3 mm jacks, bal.) for connecting
units with line output level (e. g. musical instru-
ments, CD players) to mono channel 1, stereo
channel 2/3 and stereo channel 4/5
Note: When connecting a mono unit to a stereo chan-
nel, only use the jack L (MONO).
5 Stereo master output MAIN OUT (6.3 mm jacks,
unbal.) for connecting an amplifier
6 Output PHONES (6.3 mm jack) for connecting
stereo headphones (minimum impedance 32 Ω)
7 Control GAIN for adjusting the input amplifica-
tion for channel 1
8 Treble control HIGH for channel 1
9 Bass control LOW for channel 1
10 Overload LED PK for channel 1;
if it is permanently illuminated, reduce the chan-
nel level by means of the control GAIN (7) and/or
the tone controls (8 and 9)
11 Panorama control PAN for channel 1 for placing
the mono signal in the stereo sound
12 Volume control LEVEL for channel 1
13 Balance control BAL for channel 2/3
14 Volume control LEVEL for channel 2/3
15 Balance control BAL for channel 4/5
16 Volume control LEVEL for channel 4/5
17 Stereo input TAPE IN (phono jacks) for connect-
ing an additional unit with line output level, e. g.
recorder for reproduction
18 Stereo output REC OUT (phono jacks) for con-
necting a recorder
19 Button TAPE TO PHONES: when the button is
pressed, the signal of the jacks TAPE IN (17) will
be switched to the headphone output PHONES
(6) and indicated via the LED VU-meter (23)
20 Button TAPE TO MIX: when the button is
pressed, the signal of the jacks TAPE IN (17) will
be switched to the master signal
21 Volume control
nected to the jack PHONES (6)
22 POWER LED
23 LED VU-meter: will indicate the level of the mas-
ter signal or, when the button TAPE TO PHONES
(19) is pressed, the level of the input signal of the
jacks TAPE IN (17)
8
for the headphones con-
24 Volume control MAIN MIX for the master signal
sent to all outputs
25 POWER switch
26 Jack AC POWER IN for connecting the plug-in
power supply unit provided
27 for model MMX-512USB only
USB port (type B) for connection to a computer;
to be used simultaneously as an output (digital
output of the master signal) and as an input (feed-
in of audio data for reproduction via channel 4/5)
2

Safety Notes

The units (mixer and plug-in power supply unit) corre-
spond to all required directives of the EU and are
therefore marked with
WARNING
The power supply unit uses dangerous
mains voltage (230 V~). Leave servic-
ing to skilled personnel only; inexpert
handling may result in electric shock.
Please observe the following items in any case:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water, high
air humidity, and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Do not place any vessel filled with liquid on the units,
e. g. a drinking glass.
G
The heat generated within the mixer must be dissi-
pated by air circulation; therefore, never cover the air
vents.
G
Do not operate the mixer and immediately discon-
nect the power supply unit from the socket
1. if the mixer or the power supply unit is visibly dam-
aged,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by skilled per-
sonnel.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the units and no liability for
any resulting personal damage or material damage
will be accepted if the units are used for other pur-
poses than originally intended, if they are not cor-
rectly connected or operated, or if they are not
repaired in an expert way.
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful to the
environment.
.