SUNTEC KLIMATRONIC HEAT WAVE STYLE 1000 Bedienungsanleitung Seite 8

Furthermore, all screws should be securely fixed in the wall and the appliance should be mounted securely! Observe the following
safety distances!
 Always place the appliance with a sufficient safety distance to inflammable materials or gases.
 For installation in bathrooms, a minimum safety distance of 60 cm in all directions to all pipe installations, wash basins, bath tubs
and showers is required! Please follow the sketches in section I!
The height of installation on a wall should be between 15 and 30 cm.
 The distance between appliance and ceiling must be at least 50 nun.
 Ensure that housing, heating element, power cord and plug are not damaged.
 Only use outlets with a mains voltage that corresponds to the rated voltage of for appliance. This appliance requires a voltage of
230V, 50Hz and a current of not more than 15A. Only connect the appliance to an outlet after checking the voltage.
OPERATING KLIMATRONIC HEAT WAVE STYLE
Item Name
Item Number
EAN-Number
Max. Heating Capacity
Input
 It consists of two switches, a thermostat control, and a power setting switch.
 At first the thermostat control should be turned clockwise to full position. The appliance starts then to warm the room at maximum
power.
The red indicator light shows this visually!
 When the desired room temperature is reached, you can turn the control back to
the position where the appliance tum off (you will hear a "click" and the green
indicator lights up).
OPERATING KLIMATRONIC HEAT WAVE LCD
Item Name
Item Number
EAN-Number
Max. Heating Capacity
Input
 Turn on the power-on switch on the
temperature value. The displayed temperature ranges from -9°C to 50°C. Meanwhile, the indicator lights for temperature and
timing are on.
 Pressing on the power key (ON/OFF/Power key) Turn on the power key will start the heater. The power indicator light will be on.
Through continuous operation of the power key, select the high heat mode  low heat mode (the low heat indicator light will be
on)  shut-down mode (both power and character indicator lights will be off).
 Press the mode key and the indicator will glitter. After pressing the "+" key or "-" key to select timing range (1 to 19 hours), the
indicator light enters a lasting lighting state.
 Press the mode key again, and the indicator light will glitter. Then press the "+" key or "-" key to select temperature range (15°C
—35°C). The indicator light enters a lasting lighting state.
 After power configuration, the LCD screen displays instant temperature. When the temperature rises to the preset value, the
heater stops heating. The power indicator light is off and its character indicator light is on.
Heat Wave Style 1000
11351
4250058311351
1800W
600/1200/1800W
Heat Wave 1000 LCD
11382
4250058311382
1000W
700/1000W
panel. Then the indicator light for instant ambient temperature is on, showing the instant
Heat Wave Style 1500
11368
4250058311368
1500W
1000/1500w
Heat Wave 1500 LCD
11399
4250058311399
1800W
600/1200/1800W
Heat Wave Style 2000
11375
4250058311375
2000W
1250/2000W
Heat Wave 2000 LCD
11405
4250058311405
2000W
1250/2000W