Master Lock CHW30300EURHRO Gebrauchsanweisung Seite 3

PROGRAMMING OR RESETTING YOUR
PERSONAL CODE
1
Open the chest. Use a thin object like a
straightened paperclip to press and hold
the reset button, located on the top of the
keypad, until the green LED flashes.
2
Enter a new 4-6 digit personal code on the
key pad. The chest will acknowledge each
acceptable keypress when green LED flashes.
• NOTE: The chest will time out and the
red light will flash if there is no key entry
within 10 seconds.
3
If the new personal code is 6 digits, the chest will accept it immediately. If the new
personal code is 4 or 5 digits, the code will be accepted 10 seconds after the last
key press. The red light will flash after 10 seconds if fewer than 4 digits are entered
and the chest will go into Standby mode.
4
Once the new personal code is accepted, the chest will automatically save and exit
to Standby mode without additional indication.
5 Test the personal code before closing the chest. If the code is invalid, repeat
steps 1-4.
• NOTE: The personal code programmed will not be erased when the battery
power is removed.
CONFIDENTIAL
Write down personal code, and keep it in a secure location.
Or visit www.registermysafe.com to store your personal code combinations.
Troubleshooting
THE PROBLEM:
Red LED blinks three times
Red LED slowly blinks for two minutes
Yellow LED blinks once every
thirty seconds
No LED indication when pressing
key pad buttons
WHY IT IS HAPPENING:
Incorrect code has been entered/
programming error
Programming error
An incorrect code has been entered three
times, chest is in lockout mode
Battery power is low
Power failure
ENABLING/DISABLING KEYPAD SOUND
1
To enable or disable the sound of the
keypad, press and hold the 1 and 9 on the
keypad simultaneously for 3 seconds.
2
If the sound is enabled, the green LED light
will flash and the beeper will sound. If the
sound is disabled, the green LED will flash but
have no sound.
THE SOLUTION:
Verify the code and re-enter or reprogram
Wait for two minutes, re-enter personal or factory code
Replace with 9 volt alkaline batteries (do not use rechargeable or any other type of
non-alkaline battery)
Replace with 9 volt alkaline batteries (do not use rechargeable or any other type of
non-alkaline battery)
Language
English
3