Shortcut Menu - Comelit 6501 Technisches Handbuch

SHORTCUT MENU

Enable video recording
The "video recording" function, if enabled, allows automatic
recording of audio-video content from the external unit
when a call is received and the audio key (
pressed.
Sat 12/06/13 01:21
INTERCOM
USER
} Press
to enable / disable the function.
» the icon turns blue and LED 2 (
in blue to confi rm the procedure has been completed.
Recordings are saved in .avi format on the SD card, in
the "video" folder. If there is no SD card, recordings will
be saved in the fl ash memory of the monitor (max. 8
recordings).
» LED 2 ( ) fl ashes and icon
indicate the presence of video messages in the
VIDEO MEMO section.
Enable video memory message
The function can be used to replay a video memory
message (see page 15) over the loudspeaker on the
external unit on receipt of a call.
} Press
to enable / disable the "video memory
message" function.
» the icon turns blue to confi rm the procedure was
completed successfully.
Screen lock function
1. Press to lock the screen for 60 sec.
2. Press CONFIRM to confi rm the screen lock.
» the screen shows: "Keypad locked".
Press CANCEL to return to the main screen.
Video memo: view and delete
video memory recordings
Audio-video content is stored in the VIDEO MEMO section.
• recorded automatically by the system when the "video
recording" function is enabled (page 12).
12
) not
CAMERAS
PROGRAMMER
) lights up
turns blue to
• or recorded by the user during a video call using the
"video menu" (see page 11).
} From the main screen, press
VIDEO section.
Viewing a recording
VIDEO MEMO
12/06/13 05:55 12/06/13 05:55
√ The blue frame indicates the videos which have already
been viewed, and the yellow frame indicates new
recordings.
} Press the video to watch the recording.
deleting a recording
VIDEO MEMO
12/06/13 05:55 12/06/13 05:55
1. Press "C" to activate the deletion function.
» the key will be activated and will turn green.
2. Select the video you wish to delete.
3. Press CONFIRM to confi rm deletion, or press CANCEL
to return to the previous screen.
Door check function
The "door check" function (if programmed) can be used to
view the image form the external unit at each door on the
list, and to check for open doors.
Sat 12/06/13 01:21
INTERCOM
USER
√ LED 1 ( ) lights up and the icon
indicate the presence of open doors.
} Press the icon
to access the OPEN DOORS
screen.
to access the MEMO
1
2
CAMERAS
PROGRAMMER
turns blue to