Access The Product; Reset To Factory Default Settings - Axis V5915 Installationshandbuch

AXIS V59 Series
If the monitor's maximum resolution does not match that of the camera, the capture mode in the
camera has to be changed to match the resolution of the monitor.
• Go to Setup > Video and Audio > Camera Settings.
• Select a capture mode that matches the monitor.
Note
• Only capture modes containing the text (HDMI) can be used with the HDMI connector.
• After changing the capture mode the camera will reboot.

Access the Product

Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/

Reset to Factory Default Settings

Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
Note
The installation and management software tools are available on the CD supplied with the
product and from the support pages on www.axis.com/techsup
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See Hardware Overview on
page 8.
3. Keep the control button pressed for about 15–30 seconds until the status LED indicator
flashes amber.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is 192.168.0.90
5. Using the installation and management software tools, assign an IP address, set the
password, and access the video stream.
It is also possible to reset parameters to factory default via the web interface. Go to Setup
> System Options > Maintenance.
18