Installation Instructions - Truma Elasi Gebrauchsanweisung Und Einbauanweisung

Installation
instructions
Fig. A: Choose a position for
the control panel (1) which is
easy to view. Drill a hole
with a diameter of 10 mm
for the cable and hose lead-
through (2). Fasten control
panel using the two enclo-
sed countersunk screws (3).
Length of connecting cable
and hose 3 m.
If necessary, an extension
cable is available (art. no.
34000-86000) measuring
5 m (this can be combined
to measure 8 m) as well as a
control panel frame (art. no.
39981-01) for concealed as-
sembly of the control panel.
Route the connecting cable
(4) and the hose (5) to the el-
ectrical safety/drain valve (6).
Fig. B: Engage the connec-
ting pin (7) in the control
knob (8) of the drain valve.
Slide pressure cylinder (9)
from above into the retaining
web (10) on the drain valve
and press firmly into the
4
clasp (11) of the drain valve
in such a way that the elon-
gated hole on the pressure
cylinder slides over the
connecting pin (7).
Slide union nut (12) onto the
hose (5). Push hose (5) firmly
into the pressure cylinder (9)
as far as it will go and tighten
with union nut (12).
Fig. C: Part the plug connec-
tor of the electrical supply
line (13) on the drain valve
and connect the connecting
cable of the remote control
(4) as shown in the connec-
ting diagram. Connect the
brown cable (14) from the
drain valve with the brown
connecting cable of the re-
mote control.
Secure the connecting cable
and hose without kinks,
using cable clips.
Then check all functions of
the appliance as specified in
the operating instructions.
The operating instructions
must be handed over to
the user!