Omni Bead Ruptor 96 Benutzerhandbuch Seite 9

Safety instructions when working
The Bead Ruptor 96 can be operated with liquid nitrogen for cyrogenic milling of milling
jars. Milling jars can be pre-cooled in a liquid nitrogen bath then placed on the Bead
Ruptor 96 for dissociation of tough materials. Cooling times and processing times will
be dependent on target material. It is highly recommended that you follow the safety
instructions for handling liquid nitrogen provided by your liquid nitrogen provider.
WARNING: Always wear protective gloves and googles when working with liquid
nitrogen. Liquid nitrogen has a temperature of -196°C and will cause severe burns
and frostbite with skin or eye contact.
Milling Jars
Stainless Steel 25 mL - set of two
Stainless Steel 50 mL - set of two
Grinding Balls
10 mm stainless - set of ten
25 mm stainless - set of five
Well Plate and Tube Adapters
Stainless Steel - set of two
PTFE - set of two. (Holds 48 x 0.5 - 2 mL
microcentrifuge or screw cap tubes)
with Liquid Nitrogen
Accessories
Order Number
27-004
27-006
27-203
27-206
27-101
27-106