Omni Bead Ruptor 96 Benutzerhandbuch Seite 10

The following fuses are required for the Bead Ruptor 96:
The following fuses are required for the Bead Ruptor 96:
• 2 x 2AT 250V (230V)
• 2 x 2AT 250V (230V)
• 2 x 5AT 250V (115V)
• 2 x 5AT 250V (115V)
• Unplug power cord from the power cord port (2).
• Unplug power cord from the power cord port (2).
• By pressing the locking device on the bottom side of the fuse compartment (1), fuse
• By pressing the locking device on the bottom side of the fuse compartment (1), fuse
holder is released and you can pull it out.
holder is released and you can pull it out.
• Replace fuses.
• Replace fuses.
• Insert fuse holder and push it, until it locks.
• Insert fuse holder and push it, until it locks.
Power Switch is not illuminated when the Bead
Power Switch is not illuminated
Ruptor 96 is on.
when the Bead Ruptor 96 is on.
Display screen is not working
Display screen is not working
"LID" appears on display
"LID" appears on display
Message "Er1" appears on
Message "Er1" appears on display screen
display screen
Message "Er2" appears on
display screen
Message "Er2" appears on display screen
Message "Er3" appears on
display screen
Message "Er3" appears on display screen
DO NOT: attempt to service the Bead Ruptor 96 in a manner other than
those discussed in this manual. For any issue that is unsuccessfully correct-
ed using this guide, please contact your authorized dealer or call
DO NOT: attempt to service the Bead Ruptor 96 in a manner other than those
Omni International at 1-800-776-4431.
discussed in this manual. For any issue that is unsuccessfully corrected using this
guide, please contact your authorized dealer or call
Omni International at 1-800-776-4431.
Replacing the Fuse
Replacing the Fuse
Troubleshooting
Troubleshooting
Error
Error
1. Check the power supply
2. Check fuses and replace if necessary
3. Call for service
Call for service
Indicates that the hood is open when the start button
was pressed. Close hood and clear message by pressing
the Start/Stop button. Press Start/Stop to begin cycle.
Motor has over heated. Turn power off and allow motor
to cool down.
The Bead Ruptor 96 is unable to reach the set vibrational
frequency. Check Milling Jars for obstructions. Switch
Power OFF and ON to clear error message.
Hood was opened during operation. The power must be
turned OFF and then ON to clear error message before
operation can continue.
1. Fuse Compartment
2. Power Cord Port
Possible Solution
Possible Solution
1. Check the power supply
2. Check fuses and replace if necessary
3. Call for service
Call for service
Indicates that the lid is open when the start
button was pressed. Close lid and clear mes-
sage by pressing the Start/Stop button. Press
Start/Stop to begin cycle.
Motor has over heated. Turn power off and
allow motor to cool down.
The Bead Ruptor 96 is unable to reach the set
vibrational frequency. Check Milling Jars for
obstructions. Switch Power OFF and ON to
clear error message.
Lid was opened during operation. The power
must be turned OFF and then ON to clear
error message before operation can continue.