Technical Data - 3M Peltor LiteCom Plus MT7H7A4310-EU Bedienungsanleitung

GB
5. MAINTENANCE (figure J)
5.1. Removing/replacing ear cushions
(J:1) Slide your fingers under the edge of the ear cushion and pull straight out.
(J:2) Insert a new ear cushion by pressing until it snaps into place (J:3).
5.2 Cleaning
Remove the ear cushions (A:5) and attenuation cushions (A:6) if you have been wearing the hearing protector for a long
time or if moisture has gathered inside the cups. Clean and disinfect the cups, headband and ear cushions regularly with
soap and warm water. Make sure the soap is known not to be harmful to the wearer. Allow the hearing protector to dry
before you use it again.
Note! Do not immerse the hearing protector in water!
5.3 Storage and operating temperature
Remove the batteries before storing the product. Do not store the hearing protector at temperatures above +55°C, (for
example on a dashboard, parcel shelf or window sill), or at temperatures below –40°C. Do not use the hearing protector at
temperatures above +55°C, or below –20°C.
6. CONFORMANCE STATEMENT
WEEE (Waste Electrical and Electronic Equipment) Symbol:
Below requirement applies in the European Union.
Do NOT dispose your product as unsorted municipal waste!
The crossed-out wheeled-bin symbol indicates that all EEE (Electrical and Electronic Equipment), batteries and accumula-
tors must be disposed of according to local law by the use of available return and collection systems.

7. TECHNICAL DATA

7.1 Attenuation values, SNR (figure K)
(K:1) Headband
(K:2) Helmet attachment
(K:3) Neckband
7.2 Explanation of the attenuation data tables
1. Frequency (Hz)
2. Mean attenuation (dB)
3. Standard deviation (dB)
4. Assumed Protection Value (dB)
5. Weight
7.3 Explanation of the table criterion levels (table L)
H=High frequencies
M=Medium frequencies
L=Low frequencies
7.4 Explanation of the table electrical audio input level (table M)
Gives the value, dB(A), of the mean sound pressure and the sound pressure standard deviation, dB(A), at a specified
Voltage, mV RMS.
7.5 Industrial safety helmet attachment (table N)
These ear-muffs should be fitted to, and used only with, the industrial safety helmets listed in the table.
7.6 Explanation of the industrial safety helmet attachment table
1. Helmet manufacturer
2. Helmet model
3. Helmet attachment (figure O)
4. Head sizes: S = Small, N = Medium, L = Large
7.7 Explanation of the testing and approval table
(P:1) This product is in conformity with the provisions set out in the following directives. Thereby it fulfils the requirements
for CE marking.
6