Assembly Of Pws Air/ Water Heat Exchanger (Side Mounting) - Pfannenberg PWI 6302C/ 400 V Betriebsanleitung

GB
3.4.2

Assembly of PWS air/ water heat exchanger (Side mounting)

1
1
1
Figure 6 - Switch cabinet exterior view
Holes for PWS air/water heat exchangers
Pos Designation
1 Holes
3 Dimensions in mm
Attaching cut-out for PWS air/water heat exchangers
Requirements
- All general requirements are fulfilled, see
- The unit is de-energized.
Required tools and material
- Saw
- Use a switch cabinet cutter, if applicable
- Protective covers
Procedure
 Use a protective cover to protect the switch cabinet from chips.
 Provide the switch cabinet with cut-out (2) and holes (1).
 For the prescribed dimensions (3) cut-out radius (4), refer to the figure Exterior view of the switch cabinet cut-
out.
 Deburr the cut edges.
 Remove chips and assembly waste from the switch cabinet.
 Cut-out and holes have been created.
Operating manual PWS and PWI 6302 C
1
1
1
General assembly requirements
086100047a © Pfannenberg GmbH
2
4
Figure 5 - Switch cabinet exterior view
Cut-out for PWS air/water heat exchangers
Pos Designation
2 Cut-out
4 Cut-out radius 10 mm
3
Page 12 / 31