Limitation Of Liability; Warranty - 3M X20 Sicherheitsanleitung

LIMITED WARRANTY
This product will be free from defects in material and manufacture for a period of three (3) years from the date of purchase,
subject to the following limitations. The following are exclusions to the above listed warranty or are subject to a different
warranty as set forth below:
(a) The warranty for lamps that are included as original equipment in the projectors is for parts only and is effective for a period
(b) The warranty period for LCD panels (including polarizers) is either 3 years from the date of purchase of the projector or
requires replacement and is otherwise eligible for warranty coverage,but the projector has exceeded 2500 hours of usage, the
3M warranty will cover the cost of labor,but not the cost of parts that require replacement.
(c) 3M Digital Projectors are designed to operate in a typical indoor environment. Product Warranty is void if used outside of
the following circumstances:
• 16 °to 29 °C (60 °to 85 °F)
• 0 –1828m (0 –6000 feet) above sea level
• The ambient operating environment should be free of airborne smoke, grease, oil and other contaminates that can effect the
operation or performance of the projector.
(d) The warranty will be void if you repair or modify the 3M Digital Projector or you otherwise damaged the product due to
misuse, neglect, mishandling or other abuse.

LIMITATION OF LIABILITY

THE FOREGOING WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, AND 3M
SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTY OF MERCHANTIBILITY AND FITNESS. 3M SHALL NOT BE
LIABLE FOR ANY DAMAGES, DIRECT, CONSEQUENTIAL, OR INCIDENTAL, ARISING OUT OF THE USE OR INABILITY
TO USE THIS PRODUCT.
Important: The above warranty shall be void if the customer fails to operate product in accordance with 3M's written
FCC STATEMENT - CLASS B: This equipment generates, uses and can radiate radio frequency energy, and if not installed and
used in accordance with the instruction manual may cause interference to radio communications. It has been tested and found to
comply with the limits for a Class "B" computing device pursuant to Subpart B of Part 15 of the FCC Rules, which are designed
to provide reasonable protection against such interference when operated in a residential installation.
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
INSTRUCTIONS TO USERS: This equipment complies with the requirements of FCC equipment provided that the following
conditions are met. The cables may have to be used with the core set to the projector side. Use the cables which are included with
Note:
operate the equipment.
EEC STATEMENT:
Video Signal Cables: Double shielded coaxial cables (FCC shield cable) must be used and the outer shield must be connected
to the ground. If normal coaxial cables are used, the cable must be enclosed in metal pipes or in a similar way to reduce the
interference noise radiation.
Video Inputs: The input signal amplitude must not exceed th
PATENTS, TRADEMARKS & COPY RIGHTS
IBM is a registered trademark of International Business Machines Corporation. Apple Macintosh and Apple Powerbook
are registered trademarks of Apple Computer, Inc. Microsoft and Windows 95 & Windows 98 are registered trademarks, and
Windows and Windows for Workgroups are trademarks of the Microsoft Corporation. Toshiba is a registered trademark of
Toshiba Corporation. Kensington is a trademark of Kensington Corporation. All other products are trademarks or registered
trademarks of their respective companies.
© 3M 2006

Warranty

3M™ Multimedia Projector X20 Product Safety Guide 13