Environment Protection; Control Panel; Temperature Regulation - Electrolux FI 5004 NA+ Benutzerinformation

1.6 Service
• Any electrical work required to do the
servicing of the appliance should be
carried out by a qualified electrician or
competent person.
• This product must be serviced by an
authorized Service Centre, and only
genuine spare parts must be used.

1.7 Environment Protection

This appliance does not contain
gasses which could damage the

2. CONTROL PANEL

Freezer Control panel
1 2
1. Pilot light
2.
ON/OFF switch
3. Temperature regulator (warmest)
4. Temperature indicator
5.
Temperature regulator (coldest)
6. Alarm light
7.
Alarm reset switch
8. Action Freeze light
9. Action Freeze switch
When the doors are closed the freezer
control panel is ON.
2.1 Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
2.2 Switching off
The freezer is shut off by pressing the ON/
OFF switch until the Pilot light and the
Temperature indicator switched off.
3 4 5 6 7 8 9
ozone layer, in either its refrigerant
circuit or insulation materials. The
appliance shall not be discarded
together with the urban refuse and
rubbish. The insulation foam con-
tains flammable gases: the appli-
ance shall be disposed according
to the applicable regulations to
obtain from your local authorities.
Avoid damaging the cooling unit,
especially at the rear near the heat
exchanger. The materials used on
this appliance marked by the sym-
bol are recyclable.

2.3 Temperature regulation

The temperature can be adjusted be-
tween -15°C and -24°C.
By pressing the Temperature regulators ,
the current temperature setting flashes on
the Temperature indicator. It is possible to
modify the setting temperature only with
flashed indicator. To set a warmer tem-
perature, press warmest Temperature
regulator . To set a colder temperature,
press coldest Temperature regulator. The
Temperature indicator displays the newly
selected temperature.
The newly selected-temperature will be
reached after 24 hours.
CAUTION!
During the stability period by the first
starting the temperature inside compart-
ment can not correspond to the tempera-
ture setting.
ENGLISH 5