OHAUS T21P Bedienungsanleitung Seite 14

EN-12
Parameters Description
F1-7
RS232C
[ x]
Output Mode*
F1-8 0
Not active
[ ]
F1-9
Display
[ x]
Brightness
F1-a
Accumulation
[ x]
Zero Band
4.4 RESTORE SETTINGS TO DEFAULT
Enter the Menu Mode (Section 4.1) and press
Press ENTER to accept the displayed setting.
The default settings will be shown.
Press SET to save the default values and exit to weigh mode.
You must turn off the indicator for the changes to be effective.
The default settings will be active when the indicator is turned on.
4.5 SET TARE CAPACITY
Enter the Menu Mode (Section 4.1) and press
Press ENTER to accept the displayed setting.
Parameters Description
Set-f3
Tare Capacity
[ ]
Press , to toggle through available settings.
Press ENTER to confirm.
Press SET to store values and return to weighing.
Calle 23B No. 81A - 62 Modelia PBX: (571) 410 28 48 Fax: (571) 263 72 24 Bogota, D.C. - Colombia.
www.tecnipesaje.com
Settings of "x"
0= output Gross, Net, Tare on PRINT key press
only (default)
1= output G.N.T., transmit continuously
2= output G.N.T., transmit continuously after
stable.
*NOTE:
RS232 setting changes will not be active until
SET key is pressed to store data; return to weigh mode
and the indicator is turned off and turned on again.
Not active
0= low
1= medium (default)
2= high
3= maximum
Accumulation key M+ is effective when stable
weight returns to within x=:
0= 0 division (default)
1= 0 to 1d
2= 0 to 2d
3= 0 to 5d
4= 0 to 10d
Settings of "x"
0= tare capacity is 2/3 Max (default)
1= tare capacity is max
tecnipesaje@tecnipesaje.com
SET-F2
to display [
SET-F3
to select [ ].
tecnipesaje@outlook.com
T21P Indicator
]