Hitachi DA-300E Bedienungsanleitung Seite 36

CAUTION: Since DA-300E is designed as a TWO-PERSON auger, never attempt to make auger work with
��
only one throttle lever control.
6) When auger is stuck while digging, and hard to pull out from ground, stop engine and lock the auger
by the lock pin which may make the job easier. (Fig. 8)
(The lock pin setting is made by turning powerhead slightiy while pushing the pin. Then twist the pin
handle clockwise to lock.)
7. Stopping
1) One or both of the two operators release throttle lever gradually to an idle position, then turn off stop
switch or button. (M. Parts)
NOTE: In case of an emergency, just turn off stop switch immediately.
2) Close fuel cock and drain fuel system for prolonged storage.
31
(1) CHOKE LEVER
(2) FUEL COCK
(3) CLOSE
(4) OPEN
(5) STARTER HANDLE
(9) CARBURETOR
(10) LOCK PIN
(11) LOCK PIN HANDLE
(T) IDLE ADJUSTING SCREW
(T)