Technical Specifications; Output Power; Change Scanner; Adjustable Mirror Mounts - Laserworld RS 400 G Bedienungsanleitung

Manual / Bedienungsanleitung: RS 400 G
Regularly clean the interior from dust, especially ensure operation of the fans. To clean the mirrors,
ideally use acetone and lens cleaning paper (fold paper to get an edge with which to clean the
mirrors). If not available, you can also use window cleaner, and a paper towel. Be careful, even light
scratches reduce the output power of the laser; always clean with strokes in one direction, to
minimize the effect of scratches. Mirrors need cleaning, when a "halo" is noticeable around the beam,
or an unusual high amount of diffuse light can be seen inside the device. When fog fluid condenses in
the device, clean all traces, and rearrange the position of fazer and/or laser.

Technical specifications

Output power:

 Lasersources: aircooled DPSS laser
 Laser class: 3b
 Modes: ILDA, DMX 512, auto, music active
 ILDA: 25pin ILDA standard Sub-D shaped 25pin connector
 Galvos: 50k scanspeed
 DMX 512: 14 channels
 Patterns: 160
 Scanangle: set to ca. 40° optical (60° max)
 Beam: ca. 3mm/1mrad

Accessories: power cable, key switch, interlock plug, manual, safety cord
 The laser comes in a flightcase.
 Input voltage: AC 110~120V or 220~240V switchable 50/60Hz
 Power consumption: 120W
 Size: 550 x 320 x 310mm (W x D x H)
 Weight: 15kg Laser, total: 28kg (with flightcase)
 Operating temperature: 10°-35°C

Loudness: <70dB

Change scanner

1. Unscrew UK M6 screws and disconnect signal
cable.
2. Loosen M4 x 10 screw and remove galvo.
3. Insert galvo, reconnect and fix signal cable.
4. Rotate galvo to center projection. Fix galvo.

Adjustable mirror mounts

1. Loosen setscrews, then adjust with X/Y
adjustable screws. Make sure beam is centered
on scanner mirrors.
2. Adjust Z-screw simultaneously.
3. Tighten setscrews.
4. When combining beams (RGY/RGB laser), first
make sure the beams are (roughly) on the same
spot on the mirrors/dichros. Then use a test
pattern (e.g. rectangle) to do fine adjustment.
For adjustments, always turn output power
down (if possible).

Troubleshooting

Problem
No power
Music mode not working
RS 400 G max. 400mW,
Possible reason
Fuse blown
Power supply defective
Microphone defective
Control board defective
Potentiometer defective
CPU defective
Page / Seite 7 von / of 16
>300mW, 532nm green
Damaged part
Fuse
+-24V
Microphone
Control board
Potentiometer
IC
Replacement
09-00-3001-01
16-03-0039-00
16-03-0001-00
26-2A-LT12V2-00
04-03-0104-01
00-89C516RD-00
Revision / Stand: Apr-10