Checking Parts; Safety Instructions; Installation Safety; Operating The Laser - Laserworld RS 400 G Bedienungsanleitung

Manual / Bedienungsanleitung: RS 400 G

Checking parts

Please check if all listed parts are included, and are not damaged. Included:
1 x Laser projector
1 x Power cable
1 x 9-pin plug
2 x key
1 x safety cord
1 x manual

Safety instructions

If the device has been exposed to great temperature changes, do not switch it on immediately.
Condensation water may damage your device. Leave the device switched off until it has reached room
temperature.
The laser must only be used for shows. Any operation has to be attended and supervised by a skilled
and well-trained operator.
Never leave this device running unattended and keep it away from children and unauthorized persons.
Keep away from heaters and other heat sources. In order to safeguard sufficient ventilation, leave 50
cm of free space around the device.
Never direct the laser beam to people or animals.
CAUTION LASER DIODE: If you open the device for cleaning, always disconnect from mains!
-HEALTH HAZARD! Never look directly into the light source, as sensitive persons
may suffer an epileptic shock!
These lasers are considered a definite eye hazard, particularly at the
higher power levels, which WILL cause eye damage. So these laser
series models supplied with a key switch to prevent unauthorized use,
warning labels and aperture labels affixed to the laser.

Installation safety

Prior to installation and operation of the laser, the paths of the beams
and effects should be considered, particularly with respect to how they
will reach the audience. If direct audience scanning is desired, then the
laser energy in the effects needs to be considered to decide if the
effects are safe for direct viewing. Always ensure, that the maximum
permissible exposure (MPE) is not exceeded in the area accesible to the public. So install the laser in
such a way, that minimum distances and heights ensure the MPE is never exceeded in the public area.
Warning labels on the device
Laser radiation
Avoid exposure
To the beam
Laser class 3b
Caution of radiation
If cover is removed
Indoor use only
At front opening:

OPERATING THE LASER

The operator has to make sure that laser radiation – also reflected laser radiation – higher than the
maximum permissible level is avoided by technical or organisational measures. (Especially with
respect to the MPE, see above.)
Make sure to use the correct voltage
If the device is used in a flying installation, the mounting brackets and an appropriate safety-rope
must be fixed.
In some countries, the operator must notify the accidence insurance and the authority for industrial
safety, before operating a laser. For more information, contact the relevant authorities.
Avoid exposure – laser radiation is emmited.
Page / Seite 4 von / of 16
Read manual
before use
Operation by qualified
personal only
Never direct laser
Beam at people
Never look directly
into beam
Revision / Stand: Apr-10