Using The Laser; Control Panel - Laserworld RS 400 G Bedienungsanleitung

Manual / Bedienungsanleitung: RS 400 G
Please consider that unauthorized modifications on the device are strictly forbidden due to safety
reasons!
If this device will be operated in any way differently than described in this manual, the product may
suffer damages and the guarantee becomes void. Furthermore, any other operation may lead to
dangers like short-circuit, burns, electric shock, etc.
Keep surrounding dry and clean.
dusty environment. Projector should be put in a water-proof housing when operated outside.
Regularly open the device (see "cleaning" further down) to check for dust inside, or if fog fluid
condenses in the housing (if so rearrange hazer and/or laser position).
Operating temperature is 10~35°C. In a new installation, check after some 15-30 minutes whether
the outlet air gets too warm. Regularly check the inside for dust deposits, especially around the fans.
Let laser cool off 10minutes after 2 hours of operation,to ensure maximum lifetime for the diode.
Distance between laser aperture and projection screen should be not less than 1 meter.
Do not turn device on and immediately off again frequently.
Do not look into the laser beam directly, especially not with optical instruments.
Do not touch the device with wet hands.
When the laser diode becomes dim or broken, please contact your dealer timely.
When returning laser to dealer/manufacturer always use original packaging.
Maintenance should be performed every 15-day period. See "cleaning" further down.

Using the laser

Caution – use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
Make sure the correct voltage is used. Connect mains. Connect an emergency switch to the 9-pin
conector on the backside (pins 1, 2). If you do not
wish to connect an emergency switch, connect the 9-
pin plug. Depending on the mode selected (see
below), laser light should come out of the opening on
the front panel – be careful.
1 Operation LED
2 Working LED: controlboard working
3 DMX LED: DMX connected
4 ILDA LED ILDA connected
5 DMX In/Out
6 Remotelock: connect emergency switch.
If no emergency switch is connected
use the 9 pin plug supplied.
7 Security switch: Laser on/off
8 ILDA connector in/out
9 Power switch: power on/off
10 Power: connect to mains

Control panel

 MODE: select mode, or go up in menu
 ENTER: confirm changes, or go down in menu
 UP/ DOWN: change DMX address
Operating modes:
Automatic mode: built-in patterns are displayed
Music active: laser is controlled from built-in microphone
"DMXAddr": DMX512 mode-. Here you can change the DMX address:
"Open": change address
"Up" & "down": increase/decrease address
"Save": save new address
"LCD display memory function":
This unit should be keep dry, do not use in the rain or damp and
save settings automatically.
Page / Seite 5 von / of 16
Revision / Stand: Apr-10