When The Work Is Done - Bosch BGB45 Serie Gebrauchsanweisung

Innenteil 9000 904 755 A_BGL45123SG 20.06.13 17:43 Seite 14
en
11*
Figure Vacuuming with accessories
Attach the nozzles to the tube or handle as required:
a) Crevice nozzle for vacuuming crevices and corners, etc.
b)Upholstery nozzle for vacuuming upholstered furniture,
curtains, etc.
c) Hard furnishings brush
For cleaning window frames, cabinets, mouldings,
etc.
12*
Figure
Hard-floor brush
For cleaning hard floor coverings
(tiles, parquet flooring, etc.)
Connect the floor tool and the telescopic tube
together.
13
Figure
Once you have switched off the vacuum cleaner, you
can use the parking aid on the back of the vacuum
cleaner if you wish to stop vacuuming for a short
time.
To do this, slide the catch on the floor tool into the
groove on the back of the vacuum cleaner.

When the work is done

14
Figure
Unplug the vacuum cleaner.
Briefly pull the power cord and release. The cord
rewinds automatically.
15
Figure
To store or transport the vacuum cleaner, use the
storage aid on the underside of the vacuum cleaner.
Stand the vacuum cleaner up on its end. Slide the
catch on the floor tool into the groove on the
underside of the vacuum cleaner.
Changing the dust bag and filters
Replacing the dust bag
16
Figure
If the dust bag change indicator lights up brightly
and evenly when the floor tool is lifted from the
carpet and the highest suction power is selected, the
dust bag must be changed, even though it may not
yet be full. In this case it is essential to change the
dust bag due to the type of material it contains.
First check that the nozzle, suction pipe and flexible
hose are not blocked, as this would also lead to the
dust bag change indicator being triggered.
17
Figure
Open the lid by moving the locking lever in the
direction of the arrow.
14
18
Figure
a)Seal the dust bag by pulling the sealing strip and
then remove it.
b)Insert a new dust bag into the holder and close the
dust bag compartment lid.
Caution: the lid will only close when the dust bag is
!
inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly
by knocking out the dirt and rinsing.
19*
Figure
Open the dust bag compartment lid (see Figure 17).
Pull out the motor protection filter in the direction of
the arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter should
be rinsed.
The filter must then be left to dry for at least 24
hours.
After cleaning, slide the motor protection filter into
the vacuum cleaner and close the dust bag
compartment lid.
Cleaning the foam filter
If your appliance is fitted with a filter frame and foam
filter, the foam filter should be cleaned at regular
intervals by tapping out the dust or rinsing the filter.
20*
Figure
Open the dust bag compartment lid (see Fig. 17).
Pull out the filter frame and foam filter in the
direction of the arrow.
Remove the foam filter from the filter frame and
clean it by tapping out the dust.
If the foam filter is very dirty, it should be rinsed.
After rinsing it, allow the foam filter to dry for at
least 24 hours.
After cleaning, place the foam filter back in the filter
frame, insert the filter frame with foam filter in the
appliance and close the dust bag compartment lid.
Caution: The vacuum cleaner must not be operated
!
without the motor protection filter.