Xenteq LBC 512-10S Gebrauchsanweisung Seite 19

E N
The charger will leave the setup-mode if the button isn't used for 10 seconds. In
this case the ' power' LED will flash two times. The chosen setting will remain in
the memory of the charger and the setting LED lights when the charger is on.
Charger as power supply
The LBC 500S has a special setting for the use as a power supply. In this case
the charger will give one, constant voltage. The users can be connected to the
charger directly, so without intervention of a battery.
Put the charger in its set up mode, as described above. Push until all 4 setting
LED's are out.
Important: the short circuit protection on the output will not work when the
charger is in its power supply mode.
POWER SUPPLY
If the charger is in its power supply function, the three charge status LED's are
used to indicate the height of the load. This way you know how much power the
charger supplies.
LED
Green, flashes
Green
Green + orange
Orange
OPTIONAL TEMPERATURE SENSOR T-SENSE1
Temperature-compensated charging is possible by
connecting the optional T-Sense1 temperature sensor.
If you want to use this temperature sensor, then it must first be activated. This
makes it necessary to intentionally choose whether or not to use temperature-
compensated charging, and your choice is monitored. It will prevent long periods
of unintentional erroneous charging. The applied compensation can be found in
the appendix (page 55).
19
AGM, CALCIUM, SPIRAL
LiFe-PO4
Current
0%
1% - 20%
21% - 40%
41% - 60%
*= factory setting
LED
Orange + red
Red
Red, flashes
Current
61% - 80%
81% - 100%
> 100%