Xenteq LBC 512-10S Gebrauchsanweisung Seite 18

Important
Protect the charger against moisture, pollution etc. This can damage the
charger internally. The cost for this repair is not covered by warranty.
SETTING THE CHARGER
Charge voltages
The LBC 500S has different charging voltages because each battery type
and/or brand needs other voltages to ensure the longest duration of life.
Therefore, the right charging voltages need to be set beforehand by means of
the 'power/mode' button. The battery may be connected, but is not required.
Important
The charger can only run the set-up mode after connection with the mains.
So when the charger for instance is reactivated from its stand-by mode, it
can't be set.
Connect the charger to the mains. Push directly afterwards, within 5 seconds,
on the 'power/mode' button. The green 'Power' LED starts flashing, which
means that the charger is in its setup-mode. By way of pressing the button you
can choose between the 'setting' LED's. Each different LED combination stands
for a voltage setting. For the voltages, see page 54.
Important
The battery manufacturer determines how his battery needs charged. The
schedule below is therefore a directive. Always check if the suggested
charging voltages match with the charging guides of your battery. Most of all
AGM batteries have a large diversity of charge voltages (for this reason, we
apply two setting suggestions). So for this battery type it is even more impor-
tant that the advised charge voltages are verified. Never set the charger to
your own opinion. This can lead to irreparable damage to the battery
SUGGESTED SETTING BATTERY TYPE
*
STANDARD CHARGING VOLTAGE (LEAD ACID)
OPEN SEMI-TRACTION, TRACTION
AGM, GEL
E N
>>>
18