AEG TB6080TW Benutzerinformation Seite 20

20 www.aeg.com
Problem
Unsatisfactory
drying result.
The loading
door does not
close
Not possible to
change the pro-
gram or option.
Not possible to
select an option.
Acoustic signal
is emitted.
No drum light
Unexpected du-
ration time on
the display.
Program inac-
tive.
Possible cause
1)
Incorrect program selection.
The filter is clogged.
Dryness (Trockengrad) option
was set to
4)
trocken) .
The load was too large.
The airflow slots are clogged.
Dirt on the humidity sensor in the
drum.
Dryness level not set to desired
level.
The condenser is clogged.
The filter is not locked into posi-
tion.
Laundry is trapped between the
door and the seal.
After cycle start it is not possible to
change the program or option.
The option you tried to select is
not available for the selected pro-
gram.
Defective drum lamp.
The drying duration is calculated
according to load size and damp-
ness.
The water container is full.
iron dry (Bügel-
Remedy
Select a suitable program.
3)
Clean the filter.
Change Dryness (Trocken-
grad) option to higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi-
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the program or option as
required.
Turn the tumble dryer off and on.
Change the program or option as
required.
Contact the service centre to re-
place the drum lamp.
This is automated — the appliance
is working correctly.
Drain the water container, push
the Start/Pause button.
2)
5)
3)
3)