Programme End; Starting A Programme; Hints And Tips - AEG LAVATHERM TB7053TW Benutzerinformation

16 www.aeg.com
The symbol
the display.
5. To deactivate the child lock, push
again the above buttons until the
symbol goes out of the view.
9.8 Buzzer (Signal) option
When the buzzer option is activated you
can hear the sound at the:
• cycle end
• anti-crease phase start and end
• cycle interruption
The buzzer option is by default always
on. You can use this option to activate or
deactivate the sound.
You can activate the Buzzer
(Signal) option with all
programmes.
To activate/deactivate the
(Signal) option:
Push at the same time and hold down
the Anti-crease (Knitterschutz) and
Time Save (Zeit Sparen) buttons.
The acoustic signal sounds to confirm
the change.

9.9 Starting a programme

To start the programme:
Push the Start/Pause button.

10. HINTS AND TIPS

10.1 Ecological hints
• Spin good the laundry before drying.
• Use the load volumes which are
specified in the programme chart.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
comes into the view on
Buzzer
The appliance starts and the LED above
the button does not flash but is stable.
9.10 Programme change
To change a programme:
1. Push the On/Off (Ein/Aus) button to
turn off the appliance.
2. Push again the On/Off (Ein/Aus)
button to turn on the appliance.
3. Set a new programme.

9.11 Programme end

Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is completed, the
symbol flashes on the display. If the
Buzzer (Signal) option is on, the acoustic
signal sounds intermittently for 1 minute.
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off (Ein/Aus) button for
2 seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g.
with a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.