Herunterladen Inhalt Inhalt Diese Seite drucken

Starting A Programme; Programme End; Hints And Tips - AEG LAVATHERM 87685DIH Benutzerinformation

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

9.6 Options
Together with the programme you can
set 1 or more special options.
To activate or deactivate the option push
the applicable button .
When the option is activated the LED
above the button or symbol on the
display comes into the view.
9.7 Child lock option
The child lock can be set to prevent the
children to play with the appliance. The
child lock option locks all push buttons
and the programme dial (this option
does not lock On/Off (Aan/Uit) button).
You can activate the child lock option:
• before you push the Start/Pause (/
Pauze) button - the appliance cannot
start
• after you push the Start/Pause (/
Pauze) button - programmes and
option selection is off.
Child lock option activation:
1. Turn on the dryer.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Push at the same time and hold
down the Dry Plus (Drogen Plus)
and Anti-crease (Anti-kreuk)
buttons .
The symbol
the display.
5. To deactivate the child lock, push
again the above buttons until the
symbol goes out of the view.

10. HINTS AND TIPS

10.1 Ecological hints
• Spin good the laundry before drying.
• Use the load volumes which are
specified in the programme chart.
comes into the view on

9.8 Starting a programme

To start the programme:
Push the Start/Pause (/Pauze) button.
The appliance starts and the LED above
the button does not flash but is stable.
9.9 Programme change
To change a programme:
1. Push the On/Off (Aan/Uit) button to
turn off the appliance.
2. Push again the On/Off (Aan/Uit)
button to turn on the appliance.
3. Set a new programme.

9.10 Programme end

Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is completed, the
symbol
flashes on the display. If the
Buzzer (Zoemer) option is on, the
acoustic signal sounds intermittently for
1 minute.
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off (Aan/Uit) button for
2 seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
• Clean the filter after each drying
cycle.
ENGLISH
17

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis