Care And Cleaning; Cleaning The Filter - AEG LAVATHERM TB7053TW Benutzerinformation

10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus (Trocken+) and
Anti-crease (Knitterschutz) buttons.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the Start/Pause button again
and again until you set necessary
degree.
6. To memorise the setting, push at the
same time the Dry Plus (Trocken+)
and Anti-crease (Knitterschutz)
buttons for approximately 2 seconds.
10.3 Deactivating the Water
container (Behälter) indicator
The water container indicator is by
default on. It starts to light at the end of

11. CARE AND CLEANING

11.1 Cleaning the filter

At the end of each cycle the indicator
Filter (Sieb) is on and you must clean the
filter.
The filter collects the fluff.
The fluff occurs while the
cloths are dried in the
tumble dryer.
the drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and indicator can be
permanently off.
To deactivate the indicator:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus (Trocken+) and
Time Save (Zeit Sparen) buttons.
One of 2 configurations is possible:
• the Water container (Behälter)
indicator: is on and the symbol
goes into the view - the
water container indicator is
permanently on
• the Water container (Behälter)
indicator: is off and the symbol
goes into the view - the
water container indicator is
permanently off
1. Open the door. Pull the filter.
ENGLISH 17