Adjusting The Squelch Threshold (Receiver Section Only); Selecting The Content Of The Standard Display - Sennheiser EMP 2015 Bedienungsanleitung

Adjusting the squelch threshold (receiver section only)

SqELCH
The amplifier's receiver section is equipped with an adjustable squelch which
eliminates annoying noise when the transmitter is turned off. It also suppresses
sudden noise when the transmitter leaves the reception area.
DiSPL

Selecting the content of the standard display

With both transmitter and receiver section you can choose the content of the
standard display i.e. whether the frequency (in MHz) or the channel number
is displayed.
Press the SET button to select the "SqELCH" menu. "SqELCH" appears on
the display; after a short pause the current squelch setting is indicated.
With the buttons you can now select a different setting. The squelch
/
can be turned off (0 dB) or adjusted in 5-dB steps from 5 dB to 40 dB.
(Selecting a smaller value reduces the squelch threshold, selecting a higher
value increases the squelch threshold.) The new setting starts flashing on
the display. Set the squelch threshold – with the transmitter turned off –
to the lowest possible value that suppresses hissing noise. With the squelch
set to a high value, the receiver section will be less sensitive to interference
but, on the other hand, the transmission range will be reduced.
Note:
If the receiver's squelch is set to "0 dB" and you turn the transmitter off,
hissing noise with high dynamics will occur.
Press the SET button to return to the top menu level. The display then
switches back to the standard display.
Press the SET button twice to select the "DiSPL" menu. "DiSPL" appears
on the display; after a short pause the current setting is indicated.
With the buttons you can now choose between:
/
Frequency:
Channel number:
The new setting for the standard display starts flashing on the display.
Press the SET button to return to the top menu level. The display then
switches to the new standard display.
"FrEqu"
"ChAnnL"
61