Becker Centronic MemoControl MC441-II Montage- Und Betriebsanleitung Seite 15

Programming the switching times
1. It is necessary to have the roller shutter or blind in the opposite final position
to the direction that is about to be set.
2. Wait for time at which the automatic control commands are to be executed.
3. At the desired time, press and hold the respective direction button until the
drive stops briefly after approx. 6 seconds and subsequently continues to the
final position.
4. Release direction key.
The receiver has now saved the current time for this direction travel.
Follow the same procedure for the opposite direction at the desired time.
When the sliding switch is set to „ ", no automatic control commands are ex-
ecuted. The stored command times remain unaltered.
Deleting the switching times
Note
Both switching times are always deleted in this process.
In order to delete the automatic set times for the UP and DOWN control com-
mands have been set, press the STOP button for 10 seconds. This is acknowl-
edged by a double click of the drive or slight movement "nodding" of the curtain.
The switching times have been deleted.
Channel
The channel of a handheld transmitter can be programmed into one or several
receivers. One or several receivers are controlled via an individual or group com-
mand respectively.
de
en
fr
nl
15