Status Leds; Using The Microsd Slot; Restoring The Factory Settings - Abus TVIP21502 Bedienungsanleitung

4.2 Status LEDs

LED
Network info LED
Status info LED

4.3 Using the microSD slot

Disconnect the power supply before inserting the
microSD card.
The microSD card can only be inserted into the socket in a
certain position. Use a narrow pointed object (such as a flat
narrow screwdriver) to insert it. When it is correctly positioned,
the card is flush with the housing surface and does not
protrude.
The card is detected by the camera when the power supply is
reconnected, and can then be used as desired.
The microSD card cannot be replaced when the system
is in operation!
To use the microSD card function, an active Internet
connection that makes the correct time available to the camera
after a restart is required (NTP function).

4.4 Restoring the factory settings

Camera restart
Restoring the factory settings
Color
Off
purple / blue flashing
(high frequent)
Blue flashing (high
frequent)
Red on continuousely
Blue on continuousely
Press the button until the blue LED goes out -> constantly red
during camera restart -> constantly blue after successful
camera restart
Press the button until the LED lights up blue constantly ->
constantly blue after successful camera restart
Description
Network cable not connected or wireless mode
Start-up procedure
Start-up procedure finished, normal working mode
Start-up procedure
IP address successfully assigned (Note: On manual
setup of IP address, a wrong IP address can be
applied. In this case the blue LED is continuously on
as well)
71
MicroSD card slot