General Guidelines; User Manual - Velleman CS200 Bedienungsanleitung

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be returned
to your distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
With your CS200 metal detector, you can search for coins, relics, jewellery, gold, and silver just about
everywhere.
The detector is easy to use. Its features include:
LCD Display: indicates the probable type of metal with an arrow, the depth of the target, DISC/NOTCH
range, the level of sensitivity, the operating mode, and low battery indication.
Three Tone Audio Discrimination: sounds distinctive tones for different types of metals.
Notch: ignores junk metal and finds valuable items by setting the disc and notch range.
Headphone Jack: lets you connect headphones (not supplied) and operate without trouble
Waterproof Search Coil: use the detector even if you must put it under water.
Note:
Your metal detector requires two 9-volt alkaline batteries (not supplied).
2.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
3. Preparation
3.1 Assembling the detector
Refer to the illustrations on page 2 of this manual.
1 search coil
2 search coil fixation system
3 stem
4 lock nut
Assembling your detector is easy and requires no special tools. Just follow these steps:
1. Remove the fixation system of the search coil (nut and bolt system). Insert the stem and align the
holes on the search coil bracket and the stem. Push the bolt through the holes and tighten with the
nut knob.
CAUTION: Do not tighten the search coil fixation too hard. Do not use tools such as pliers to
tighten it.
2. Insert the arm support into the end of the stem and tighten the lock screw at the back of the control
housing.
3. Turn the stem's lock nut clockwise until it loosens.
4. Adjust the stem length to have the search coil level with and about ½ to 2 inches above the ground
when you stand upright with the detector in your hand, your arm relaxed at your side.
5. Turn the stem's lock nut counter-clockwise to lock it in place.
6. Wind the search coil cable around the stem. Leave enough slack in the cable. Insert the search coil's
plug into the search coil jack on the detector's control housing.
CAUTION: The search coil's plug fits into the jack only one way. Do not force the plug or you could
damage it.
7. Loosen the search coil fixation knob, adjust the search coil to the desired angle and tighten the nut
knob.
V. 03 – 06/01/2016
CS200

USER MANUAL

5
6
7
3
cable
control housing
arm support
©Velleman nv