Storch 43 61 20 Bedienungsanleitung Seite 55

life of the knife. The HotKnife 36 V reaches the preset temperature in just a
few seconds. Releasing the trigger one or two centimetres before the end of
the cut avoids cooling polystyrene sticking to the blade.
Caution: The selected blade should not be much longer than the thickness of
the material you are cutting. During cutting, the blade is cooled by the mate-
rial. The uncovered part of the blade can overheat and cause distortion of the
blade.
Warnings:
1. Before starting up the device, read the manufacturer's warnings con-
cerning the flammability and toxicity of material you will be cutting.
2. Only work in well ventilated rooms. Use an extractor unit if possible.
3. Never burn off excess residue on the blade! The blade and the device
can overheat and the blade can warp. Use the brush provided for clea-
ning.
4. Only operate the HotKnife 36 V while it has direct contact with the
material to be cut.
5. Keep the hot blade well away from your skin, clothes and other flam-
mable materials to avoid burns and accidents.
6. Allow the blade to cool down sufficiently before you touch it.
hot blade can cause injuries or burns.
55
A