Replacing The Lamp; Electrical Connection - Zanussi ZRA33104WA Benutzerinformation

Problem
Door does not open easily.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.

REPLACING THE LAMP

The appliance is equipped with a long-
life LED interior light.
It is strongly recommended to use
original spare parts only.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
CAUTION! Disconnect the plug from
the mains socket.
INSTALLATION
WARNING! Refer to Safety chapters.
POSITIONING
This appliance can be installed in a dry, well
ventilated indoor where the ambient temperature
corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Possible cause
Stored food was not wrap-
ped.
You attempted to re-open the
door immediately after clos-
ing.
1. Pull the left side of the lamp cover with your
fingers to unlock it. Remove the cover by
pulling it towards yourself.
2. Replace the bulb with one of the same power
and shape, specifically designed for household
appliances.
3. Install the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.

ELECTRICAL CONNECTION

• Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
• The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
INSTALLATION OF THE APPLIANCE AND
DOOR REVERSAL
Solution
Wrap food in suitable packaging
before storing it in the appliance.
Wait a few seconds between
closing and re-opening of the
door.
Please refer to separate instructions
on installation (ventilation
requirements, levelling) and door
reversal.
1
2
1
31