Herunterladen Inhalt Inhalt Diese Seite drucken

Replacing The Lamp - Zanussi ZBA23042SA Benutzerinformation

Vorschau ausblenden Andere Handbücher für ZBA23042SA:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Problem
The compressor does not start
immediately after pressing the , or
after changing the temperature.
Water flows on the rear plate of
the refrigerator.
Water flows into the refrigerator.
Water flows on the floor.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.

Replacing the lamp

The appliance is equipped with a
longlife LED interior light.
CAUTION!
Disconnect the plug from the mains
socket.
1. At the same time, with the fingers expand
up and down the transparent cover and
unhook it in the direction of the arrows.
18
Possible cause
Food products placed in the ap-
pliance were too warm.
The door is not closed correctly.
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost melts on the rear
plate.
The water outlet is clogged.
Food products prevent that water
flows into the water collector.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature
is too high.
Many food products are stored at
the same time.
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in
the appliance.
2
2. Replace the lamp with one of the same
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
The compressor starts after a pe-
riod of time.
This is correct.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Make sure that there is cold air
circulation in the appliance.
1
1
power and shape, specifically designed for
household appliances. (the maximum power
is shown on the light bulb cover).
Solution
www.zanussi.com

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Zba23042sv933033007

Inhaltsverzeichnis